Heating Regulations

Regulations driving commercial heating change

The compliance obligations that are making conventional central heating systems progressively more expensive to keep — and what EHP® radiators change in that calculation.

Why regulations matter more than incentives here

Grants reduce the cost of acting. Regulations increase the cost of not acting. That is a different kind of pressure — and for most commercial building owners, it is the more urgent one.

Across Sweden, the United Kingdom, Ireland, and the Netherlands, the regulatory environment for commercial heating has shifted materially in the last three years. Mandatory energy audits now require buildings to document and address heating losses that were previously invisible. Building energy performance standards are setting minimum thresholds that conventionally heated buildings will struggle to meet. And the trajectory — embedded in EU directives and national transpositions — points toward progressively tighter requirements through 2030 and beyond.

EHP® (Enhanced Heat Performance) nanotechnology radiators are not designed around any specific regulation. They are designed to deliver more heat from less energy. That design happens to satisfy the performance requirements that regulation is now mandating — not as a compliance product, but as a consequence of how the technology works.

The qualifying mechanism

Why EHP® radiators satisfy regulatory frameworks by design

Three characteristics make EHP® central heating radiators structurally compatible with the regulatory direction of travel across all four markets.

Operating temperature. EHP® radiators operate at a supply temperature of 30–35°C. The Energy Performance of Buildings Directive (EPBD 2024) sets near-zero energy performance requirements that favour low-temperature heating systems. Heat pumps — the technology most commonly cited as a route to compliance — require low-temperature emitters to reach meaningful COP values. EHP® radiators satisfy that requirement directly: an existing building fitted with EHP® central heating radiators is heat-pump-ready from day one, without a change to the distribution system.

Energy consumption reduction. EHP® radiators reduce heating energy consumption by up to 55% against conventional central heating radiators operating at 55–80°C. Energy audits conducted under ESOS (UK), EKL (Sweden), and the EED recast (Ireland) are required to identify the highest-ROI energy interventions in a building. Heating is almost always among them. An EHP® installation addresses the most significant audit finding — the one the auditor will highlight, the one the compliance scheme will expect to see actioned.

No F-gas exposure. EHP® radiators operate on a sealed, non-corrosive working fluid — not a refrigerant. They carry no liability under the EU F-gas Regulation (EU) 517/2014 or its 2024 recast. Buildings that also operate refrigerant-based cooling systems face progressive F-gas phase-down obligations through 2030. EHP® radiators create no additional exposure and require no refrigerant handling, no phase-down planning, and no F-gas registered engineer for installation or maintenance.

EU-wide framework

EPBD 2024 — the directive behind the national obligations

The Energy Performance of Buildings Directive (Directive EU/2024/1275), adopted in May 2024, sets the EU-wide framework within which national heating regulations operate. Understanding it explains why the national instruments described on each country page are converging on the same outcome.

Minimum energy performance standards (MEPS). EPBD 2024 requires member states to ensure that the worst-performing 16% of non-residential buildings meet a minimum energy performance threshold by 2030, rising to 26% by 2033. Member states must identify these buildings and establish national trajectories. Ireland and the Netherlands are EU members and implement this directly. The United Kingdom and Sweden operate outside the EU framework but have equivalent national instruments — MEES and EKL respectively — that produce comparable obligations.

Near-zero energy buildings. New and substantially renovated commercial buildings must meet a near-zero energy building (NZEB) standard. Heating specification in new builds and major renovations is now a compliance question, not purely a design preference. Low-temperature heating systems — including EHP® central heating radiators — satisfy the NZEB heating requirement in a way that conventional high-temperature systems do not.

BACS mandate. From 1 January 2026, EPBD 2024 requires building automation and control systems (BACS) in non-residential buildings with HVAC systems above 290 kW. EHP® radiators operate at lower temperatures and reduced system load — a building with EHP® installations is more likely to fall below the BACS threshold, or to satisfy it more efficiently.

The practical consequence. A commercial building owner in any of HNordic's four primary markets is now operating under a regulatory framework that will require documented energy performance improvement by 2030. The audit obligation identifies the requirement. The performance standard sets the target. EHP® radiators address the most significant source of heating energy loss — before any other intervention is needed.

Sweden

Sweden: mandatory audit cycle and building energy labelling

Two instruments shape the Swedish regulatory environment for commercial heating: the enterprise energy audit obligation under the EKL Act (transposing the EU EED recast), and the Swedish energideklaration — the building energy certificate required on sale, rental, and for buildings above a size threshold.

Swedish EKL — EED Recast 2023/1791. Enterprises consuming more than 10 TJ per year were required to complete an energy audit by 11 October 2026. That deadline has now passed. Enterprises that completed the audit have entered a four-year compliance cycle — the next audit falls due in October 2030. The audit finding for heating is predictable: systems operating at 55–80°C with high thermal mass are identified as the highest-ROI intervention in almost every commercial building. EHP® radiators address that finding directly.

Swedish energideklaration. The building energy certificate records the building's specific energy use per square metre. Heating efficiency improvement reduces the specific energy figure — which moves the building up the energy class scale and affects both lettability and valuation. An EHP® installation improves the energideklaration rating measurably, without structural changes to the building.

Full detail on Swedish regulations →

United Kingdom

United Kingdom: audit obligation and landlord performance standards

Two instruments apply to UK commercial buildings: ESOS Phase 4 — the mandatory energy audit scheme for large organisations — and MEES Non-Domestic, which sets minimum energy performance standards for rented commercial property.

ESOS Phase 4. Organisations with 250 or more employees, or with annual turnover above £44 million and a balance sheet above £38 million, are required to complete an energy audit and submit a compliance notification by 5 December 2027. The audit must identify significant energy consumption and recommend cost-effective improvement measures. Heating consistently represents the largest single energy consumption category in commercial buildings. An EHP® installation addresses the headline audit finding — and produces documented energy savings that satisfy the ESOS recommendation requirement.

MEES Non-Domestic. Commercial landlords in England and Wales are currently required to hold a minimum EPC rating of E for any tenanted property. The trajectory tightens: EPC B is required for buildings above 1,000 m² by 1 January 2031. EHP® central heating radiators are a direct EPC improvement measure — reduced heating energy consumption moves the building's asset rating upward. For landlords managing multiple properties against a 2031 deadline, EHP® installations are among the highest-impact interventions available.

Full detail on UK regulations →

Ireland

Ireland: enterprise audit obligation and EU performance trajectory

Ireland operates two regulatory instruments relevant to EHP® installations: the Energy Auditing Compliance Scheme administered by SEAI — Ireland's transposition of the EED recast enterprise audit obligation — and the EPBD 2024 MEPS trajectory, which Ireland implements as an EU member state.

Energy Auditing Compliance Scheme. Irish enterprises consuming more than 10 TJ per year were required to complete an independent energy audit by 11 October 2026. Enterprises above 85 TJ must implement a certified energy management system by 11 October 2027. SEAI offers a €2,000 audit voucher — the Support Scheme for Energy Audits — to reduce the cost of commissioning the required audit. Heating is the primary intervention identified in most Irish commercial building audits; EHP® installations directly address the finding.

EPBD MEPS — Irish transposition. As an EU member state, Ireland is required to ensure that the worst-performing 16% of non-residential buildings meet a minimum energy performance threshold by 2030, rising to 26% by 2033. Buildings currently in the bottom quartile of energy performance — those most reliant on high-temperature heating systems — are most exposed. EHP® central heating radiators reduce heating energy consumption by up to 55%, moving buildings away from the performance floor where MEPS obligations concentrate.

Full detail on Irish regulations →

Netherlands

Netherlands: mandatory energy labelling and EPBD trajectory

The Netherlands operates one of the most advanced building energy labelling regimes in Europe. Office buildings above 100 m² are now required to hold a minimum energy label C — active enforcement began in 2026. The label A trajectory extends to 2030. EHP® central heating radiators are a primary improvement measure for office buildings currently rated D or below.

Mandatory Energy Label C. Dutch office buildings that cannot demonstrate compliance with energy label C are at risk of being taken out of use by enforcement authorities. The Omgevingsdiensten — regional environmental agencies — are the enforcement body; non-compliant buildings are reported through the RVO EP-online register. An EHP® installation improves the building's specific energy index (EI) directly — heating is the single largest contributor to the index, and reducing it moves more buildings into compliance than any other single measure.

EPBD MEPS — Dutch transposition. Beyond the current label C obligation, the MEPS trajectory under EPBD 2024 requires the worst-performing 16% of non-residential buildings to meet a minimum threshold by 2030. Dutch buildings already below label C are in the scope of both obligations simultaneously — the current enforcement regime and the approaching MEPS deadline. The label A trajectory by 2030 represents a material performance improvement requirement for a large share of the Dutch commercial building stock.

Full detail on Netherlands regulations →

Worth knowing

The F-gas position no competitor will mention

The EU F-gas Regulation (EU) 2024/573 — the 2024 recast — accelerates the phase-down of hydrofluorocarbons through 2030 and beyond. Buildings operating refrigerant-based cooling systems face increasing costs for refrigerant replacement, engineer certification, and leak reporting. Most energy upgrade conversations in commercial buildings happen alongside cooling system conversations — and most heating product suppliers have no position on F-gas because their products create no F-gas exposure.

EHP® radiators use a sealed, non-corrosive working fluid that is not a refrigerant. There is no F-gas registration required for installation or maintenance. There is no phase-down schedule to plan around. There is no refrigerant handling obligation. For a building owner managing both a heating upgrade and a cooling system that carries F-gas liability, EHP® radiators reduce the compliance surface rather than adding to it. That is not a product claim. It is a consequence of what the working fluid is.

Regulatory query

What applies to your building

Tell us your market, your building type, and the compliance deadline you are working to — we will advise on how EHP® radiators fit your regulatory position.

Get in touch Heating Incentives