A heating system that operates at 30–35°C changes what is achievable in low-energy building design — from the plant room to the passive house standard.
Nearly every current building standard — EPBD 2024 across the EU and Ireland, Part L in the UK, passive house, BREEAM, LEED — requires heating systems that operate efficiently at low supply temperatures. The logic is consistent: a building designed to lose less heat should be heated by a system that generates heat efficiently. High-temperature radiators are a fundamental mismatch with low-energy building design.
The problem is not the heat source. Heat pumps are now standard specification for commercial low-energy buildings, and they are designed to operate at 35–45°C. The problem is that most radiators require 55–80°C — which forces the heat pump above its efficient operating range, invalidates the modelled energy performance, and introduces a compliance gap that is difficult to close without replacing the heat distribution system.
EHP® radiators operate at 30–35°C. They are specified for the supply temperature the heat pump was designed to deliver.
EPBD 2024 requires near-zero energy performance in new and substantially renovated commercial buildings. A heating system operating at 30–35°C and delivering up to 55% less energy consumption than a conventional radiator system is a measurable contribution to that standard — specified in before tender, not retrofitted after practical completion.
When EHP® central heating radiators is specified alongside a heat pump, the heat pump operates within its designed temperature range from day one. The gap between modelled and actual energy performance — a persistent problem in low-energy commercial buildings — does not open.
EHP® radiators contain a sealed working fluid. No inhibitor. No annual flush. No pressure testing. No service access required in the building specification. This is a direct simplification of M&E coordination and long-term maintenance planning.
EHP® working fluid is not a refrigerant. No F-gas regulation applies. No leak detection requirement. No F-gas competency requirement for installers. This is relevant for any specification that includes both EHP® radiators and refrigerant-based cooling — the two systems are independent.
5th-generation district heating networks operate at 25–35°C. Conventional radiators cannot operate at this supply temperature without being oversized by roughly 2.5× — which is not a retrofit adjustment, it is a full system replacement. EHP® radiators operate at 30–35°C as their primary condition.
The infrastructure is developing at scale. Sweden is committed to decarbonising district heating by 2030. The UK introduced Ofgem regulation of heat networks in January 2026 and is targeting 7% of national heat demand from district heat networks by 2035, with Heat Network Zoning now designating geographic areas where connection will be required or prioritised. Norway and Denmark are expanding existing district heating networks that already supply 10–15% and 60% of heating demand respectively.
The specification decision is whether a building is compatible with this infrastructure when it arrives. A building specified with conventional radiators is not — it requires a full radiator replacement to connect. A building specified with EHP® radiators connects without modification. For new-build and major retrofit projects, this is not a future consideration. It is a present-day design decision with a 25-year consequence.
EHP® central heating radiators connect to existing pipework. For retrofit and refurbishment projects — commercial buildings changing use, EPC improvement programmes, listed buildings where the heating system is being upgraded — EHP® radiators replace existing radiators with no pipework modification. The existing boiler or heat pump remains. The supply temperature requirement drops to 30–35°C.
EHP® electric radiators is available for spaces where pipework retrofit is not practical — individual offices, listed interiors where surface-mounted pipework is not permissible, temporary or phased occupation.
Technical specification documentation is available on request for inclusion in contract document packages. This includes:
EHP® radiators are the heating component of HNordic's integrated energy infrastructure. For building projects considering on-site generation alongside efficient heating — cylindrical wind turbines, battery storage, and EHP® radiators as a combined specification — HNordic provides a whole-system assessment at design stage.
Next step
We provide specification documentation and technical input at design stage — before tender, before planning, at the point where it changes the building.
Get in touch Technical detail